Venmar HV 1.5 Manuel d'utilisateur

Installation and User ManualVB0063AE60 - EA 1500 - HV 1.5RESIDENTIAL USE ONLYREAD AND SAVE THESE INSTRUCTIONSINSTALLER: LEAVE THIS MANUAL TO THE HOMEO

3. INSTALL THE UNIT (CONT’D) 3.5 INSTALLING 6” DUCTS AND REGISTERS (CONT’D)103.5.3 SUGGESTED REGISTER LOCATIONS (CONT’D)MULTI-LEVELBasement stairwell

3. INSTALL THE UNIT (CONT’D) 3.6 INSULATED FLEXIBLE DUCTS INSTALLATION11CAUTIONMake sure the vapor barrier on the insulated ducts does not tear durin

1. For each duct, pull back the insulation to expose the interior flexible duct.2. Connect the interior flexible duct to the smaller part of the Tan

3. INSTALL THE UNIT (CONT’D) 3.7 EXTERIOR OPENING(S) INSTALLATION (CONT’D)13CAUTIONThe Tandem transition must be inserted in such way that the exhaus

3. INSTALL THE UNIT (CONT’D) 3.7 EXTERIOR OPENING(S) INSTALLATION (CONT’D)14CAUTIONThe exterior backplate must be installed with the word “TOP” point

3. INSTALL THE UNIT (CONT’D) 3.7 EXTERIOR OPENING(S) INSTALLATION (CONT’D)CAUTIONDue to its particular design, the dual exterior hood must be used on

3. INSTALL THE UNIT (CONT’D) 3.7 EXTERIOR OPENING(S) INSTALLATION (CONT’D)CAUTIONMake sure the insulated ductwork vapor barrier does not tear during

3. INSTALL THE UNIT (CONT’D) 3.7 EXTERIOR OPENING(S) INSTALLATION (CONT’D)3.7.4 LOCATING TWO SOFFIT GRILLES17If this unit is installed in the attic,

4. CONTROL 4.1 INSTALLATION OF THE CONTROL18CAUTIONNever install more than one control per unit.2. Remove the cover plate control (1). If you prefer

4. CONTROL (CONT’D) 4.1 INSTALLATION OF THE CONTROL (CONT’D)196. Route the cable to the unit.7. Remove the electrical box cover on the side of the

1. This unit is intented for residential installation only.2. Use this unit only in the manner intended by the manufacturer. If you have questions,

4. CONTROL (CONT’D) 4.1 INSTALLATION OF THE CONTROL (CONT’D)209. Splice back the end of the cable to access the 4 wires. Remove the insulated slee

4. CONTROL (CONT’D) 4.2 OPERATING THE CONTROL (CONT’D)21• “O”: To stop the unit, slide the button on this position.• MINIMUM: For a day-to-day usag

5. MAINTENANCE 5.1 BIANNUAL MAINTENANCE222. Clean filter • Remove filter. • Vacuum to remove most of the dust. • Wash with a mixture of warm water

5. MAINTENANCE (CONT’D) 5.2 ANNUAL MAINTENANCE232. Clean filter • Remove filter. • Vacuum to remove most of the dust. • Wash with a mixture of warm

5. MAINTENANCE (CONT’D) 5.3 MASTER RESET24Use the master reset only if you perform the annual maintenance before the annual maintenance indicator is

TABLE OF CONTENTS1. YOUR UNIT AND ITS PURPOSE...42. TYPICAL INSTALLATIONS ...

1. YOUR UNIT AND ITS PURPOSEOPERATIONAL PRINCIPLESThe air exchanger is designed to eliminate problems of excessive humidity, to steady the temperature

2. TYPICAL INSTALLATIONSUse the following illustrations as guidelines to help you decide where your unit will be installed. The unit should be hung to

2. TYPICAL INSTALLATIONS (CONT’D) 2.3 MOUNTING CONSIDERATIONSVJ00306This unit can be used for a retrofit application. Connect the existing ducts to t

3. INSTALL THE UNIT 3.1 LOCATING AND MOUNTING THE UNIT7Choose an appropriate location for the unit, far from the areas of the house where peace and q

3. INSTALL THE UNIT (CONT’D) 3.4 PLANNING OF THE DUCTWORK8 • Keep it simple. Plan for a minimum number of bends and joints. Keep the length of

3. INSTALL THE UNIT (CONT’D) 3.5 INSTALLING 6” DUCTS AND REGISTERS (CONT’D)93.5.3 SUGGESTED REGISTER LOCATIONSBUNGALOWBasement stairwell (A): Open, l